transverse stress

The basic equations of elliptic plate, when temperature and stress fields are coupled, are developed, which include transverse thermal vibration equation, the compatibility equation and energy equations.

本文首先推导了当温度场和应变场耦合时椭圆板的非线性热弹耦合振动的基本方程，其中包括横向热振动方程、协调方程和能量方程。

The forging method without the transverse tension stress is proposed based on the methods described above.

在此基础上提出了横向无拉应力锻造法。

The maximum horizontal tensile stress and the maximum transverse tensile stress both occurred at the repaired joint between the bottom of polyurethane facing concrete and the top of granular groundwork.

最大水平拉应力和最大横向拉应力均出现在修补后的聚氨酯混凝土面层与粒料基层交接面。

With the increasing of strip width, the transverse difference of front tension stress decreases firstly, and then increases.

随着板宽的增加，前张应力沿横向的差距先减小后增大。

The results found that: ( 1) the transverse corner field resulting from the uneven geometrical width of YBT model leads to the non-uniform spreads and distributions of the active lengthwise tensile stress, the stretchy strain and the passive transverse pressure stress in the principal axis;

由此得出：①YBT模型几何宽度不均匀所形成的横向角部区域，导致了主动型的纵向主轴拉应力和主轴伸长应变以及被动型的横向主轴压应力的不均匀传播与分布；

The fracture toughness Klc will be calculated by the transverse flow stress of tube wall and the actual maximum diameter of the aperture.

可以通过测量射孔后管壁的横向流变应力和孔眼的实际最大尺寸来计算套管在射孔过程中不开裂的断裂韧性指标K（Ic）。

Calculation for Transverse Distribution of Tension Stress in Rolling Strip on 4-High Mill

四辊冷轧带材中张应力横向分布的求解

The enhancement mechanism of hybrid fiber was investigated by observing the SEM photos of cross section. The main factors affecting the hybrid effect coefficient were presented and the relationship among this coefficient, transverse tensile strength and stress relaxation rate of NAFC materials was discussed.

利用扫描电镜（SEM）分析了材料拉伸断面形貌，探讨了混杂纤维增强机制，分析了混杂效应系数的主要影响因素，研究了混杂效应系数与材料横向抗拉强度和应力松弛率之间的关系。

The transverse stress increases with the increase of tensile strain.

在塑性变形阶段，试样宽度方向应力的绝对值随拉伸应变的增大而增大；

Results: In the injured side, the stress changed obviously, especially in anterior oblique surface and transverse ridge of condyloid process.

结果：患侧髁突表面应力分布发生了明显改变，尤以髁突前斜面和嵴顶部最为显著；

The phenomenon of longitudinal fission seldom occurred during the process of tube plug drawing mill compared with empty-sunken steel tube. The problem which seldom cause transverse fissure in form of partial failure owing to uniform distribution of axial stress in cross section.

与空拔相比较，在短芯棒拔制过程中，纵裂现象一般不会发生，由于钢管轴向应力在横截面上分布均匀，一般也不会出现以局部破坏形式出现的横裂现象。